Standard Precision Electronics
SOC
SOC
$50.00
TO TEST EJACULATOR:  Unit should be fully charged (8 hrs), turn switch to
“Test”.  Meter should read above 300.  Turn switch to “Batt”, turn power switch
clockwise until meter reads 50-150.  Now plug “SOC” into 3-pin connector on side
of unit.  Meter should jump to higher reading.  Always return Power switch to full
counterclockwise position.





TO TEST PROBE CORD:  With unit still in  “Batt” position, plug Probe cord into
unit.  Turn power switch clockwise until meter reads 50-150.  Plug  “SOC” into open
end of  Probe cord.  Meter should again jump.  Always return Power switch to full
counterclockwise position.






TROUBLESHOOTING:  If the above tests do not pinpoint the problem your probe
may be the cause.  If the above tests seem satisfactory send the probe in for
evaluation to: SPE,  10325 Wadsworth Blvd,  Broomfield, CO 80021.

BULL SEEMS OVERSENSITIVE:  If this is a problem i.e. young bulls. you may want
to reduce the power to the probe.  Plug the “SOC” into the unit.  Plug the probe
cord into the “SOC” then into the probe.